Online Catalog



Model Name :
Heat Sink
Height (h) Weight
11.5 mm 26.6g
  Push pins Springs
-------- --------
No push pin and spring required
  • To order individual components, such as push pins or springs, please visit each link/page.
  • Customization

    If heatsink customization (size, hole layout, etc...) is required, please contact us. MOQ is 1 piece, typical lead time is 1-2weeks.

 Thermal Interface
No thermal interface required


The thermal interface materials listed here are phase change materials (PCMs). These PCMs are naturally tacky and will be pre-applied to the heat sink. However, PCMs may peel-off from the heat sink base when removing the release liner prior to heat sink installation. Since PCMs rely on their natural tackiness instead of an adhesive, this can happen. In light of this, we recommend that our customers apply additional pressure to the PCMs prior to removing the protective liner to allow the PCMs to wet out on the heat sink surface (refer to instruction item #4 below). Storage and Handling Instruction

Dimension and Thermal Data
Contact | © 2021 Alpha Company Ltd.