Online Catalog

QTLM40

QTLM40 SPECIFICATION & THERMAL DATA

Model name :
QTLM40-
{{boxModelName.HSHEIGHT}}
B
-
{{boxModelName.SETTYPE}}
{{boxModelName.SPR}}
{{boxModelName.ANC}}
{{boxModelName.TIM}}
catalog RoHS REACH
Step 1: Select Heat Sink Height
Step 2: Select Torsion Springs and Anchors
Step 3: Select TIM
Heat Sink (Height h) Weight
{{getWeight(hsHeight)}} g
{{getWeight(INP.SELHSHEIGHT)}} g
  Torsion spring Anchor pin
{{INP.SPRNO}} {{INP.ANCNAME}}
Thermal Interface
Note

The thermal interface materials listed here are phase change materials (PCMs). These PCMs are naturally tacky and will be pre-applied to the heat sink. However, PCMs may peel-off from the heat sink base when removing the release liner prior to heat sink installation. Since PCMs rely on their natural tackiness instead of an adhesive, this can happen. In light of this, we recommend that our customers apply additional pressure to the PCMs prior to removing the protective liner to allow the PCMs to wet out on the heat sink surface (refer to instruction item #4 below).

Storage and Handling Instruction

  • Heat sinks and torsion springs can be purchased as assembled parts only, not separately.
  • For ordering the individual components, like anchor pin or thermal interface, please visit each link.
Dimension and Thermal Data
Board keepout patterns and load chart

© 2018 Alpha Company, Ltd.